1·Cryogenic burns which result in blistering or deeper tissue freezing should be seen promptly by a physician.
导致起泡或深层组织结冻的低温烧伤应该迅速由医生来处理。
2·The causes of the front fog lamp shield blistering after surface treatment are studied by means of metalloscopy scanning electronic microscope and energy spectrum analysis.
运用金相显微镜、描电镜和能谱仪，研究了前雾灯遮光罩表面处理后起泡的原因。
3·Ensure that the product does not automatically blistering, cracks, cracking, peeling or shedding from the glass surface.
保证产品不会自动起泡、出现裂纹、破裂、起皮或从玻璃表面脱落。
4·Humidity - humidity so high that the coating adhesion with the wall fell, resulting in coating blistering and blur, so the humidity is less than 10%.
湿度—湿度过高使涂膜与墙体附着力下降，造成涂膜起泡和发花，故湿度要求小于10%。
5·The result indicated when the epoxy primer in which the content of the PVC was higher than that of the CPVC was recoated, it would cause blistering on the paint film.
结果表明，在PV C含量高于CPVC的环氧底漆上复涂时，会引起所复涂涂料起泡的漆膜缺陷。