1·Rotational deformation of the shaft will produce maximum deflection.
转动的泵轴会弯曲变形，产生最大挠度。
2·Tested the joint stiffness based on "deflection method", and analyzed the factors that affect joint stiffness according to the test results.
基于“挠度法”，对节点刚度进行了测试。根据测试结果，分析了影响节点刚性的各种因素。
3·The result indicated that, the section upper and lower reason stress error is about 5% while stepping, the deflection error, about 1%.
计算结果表明：跨中截面上下缘应力计算值与试验值误差在5%左右，跨中挠度误差在1%左右。
4·The deformations (deflection value) of the patterns with different coatings were measured under different loads.
测试涂挂不同涂料的模样在变载荷下的挠度值。
5·Based on the piezoresistive effect, large or small deflection theory, thin film's stress theory and other mechanics or electricity knowledge, a piezoresistive micro pressure sensor is designed.
利用压阻效应、大(小)挠度理论、膜的应力形变等力学、电学知识设计了一种压阻式微压力传感器。